Quick Shifter; Brake Lever - Yamaha NIKEN GT 2021 Owner's Manual

Instrument and control functions

Quick shifter

The quick shifter allows for full-throttle,
clutch lever-less, electronically-assist-
ed upshifts. When the shift switch de-
tects motion in the shift pedal, engine
power and drive torque are momen-
tarily adjusted to allow the upshift to
4
occur.
TIP
 The quick shifter operates when
traveling at least 20 km/h (12 mi/h)
with an engine speed of 4000
r/min or higher, and only when ac-
celerating.
 The quick shifter does not operate
when the clutch lever is pulled.
To turn the system off
1. Turn the main switch off.
2. Move the shift pedal upward so
that the shift rod is partially re-
tracted into the shift switch, and
hold it in that position.
EAU84561
1
2
1. Shift switch
2. Rod
3. Turn the main switch on, and after
10 seconds release the shift ped-
al.
4. " " will disappear.
TIP
To turn on the quick shifter, perform
the same procedure.
4-18

Brake lever

The brake lever is located on the right
side of the handlebar. To apply the
front brake, pull the lever toward the
throttle grip.
1
3 4
1. Brake lever
2. Distance
3. Brake lever position adjusting dial
4. Match mark
The brake lever is equipped with a
brake lever position adjusting dial. To
adjust the distance between the brake
lever and the throttle grip, push the
brake lever away from the throttle grip
and rotate the adjusting dial. Make
sure the setting number on the adjust-
ing dial aligns with the match mark on
the brake lever.
EAU26827
2