Table of Contents
Advertisement
Advanced 1 Feature
Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press
▲▼ to move to the Advanced 1 menu and then press Enter or ►. Press ▲▼ to move up and down
in the Advanced 1 menu. Press ◄► to enter and change values for setting.
I
TEM
Press ◄► button to enter and select different OSD location.
Menu Position
Translucent Menu
Press ◄► to enter and turn Low Power Mode Off, Low Power or On By Lan.
Low Power Mode
Press the cursor ◄► button to enter and toggle between Normal and High fan
speeds.
Fan Speed
Note: We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas.
After replacing the lamp, this item should be reset. See page
Lamp Hour Reset
on
Press the cursor ◄► button to enter and adjust a two digit projector ID from 0 through
Projector ID
98.
Press
Network
Network
Note:
About "On By Lan", RJ45 will support to be waked up in this mode(Under 6W) but scalar won't.
Press ◄► button to enter and select OSD background translucent level.
Lamp Hour
Reset.
(Enter) / ► to enter the Network menu. See page
.
D
ESCRIPTION
— 34 —
35
for more information
35
for more information on
Advertisement
Table of Contents
