RCA Jack is not designed to be connected directly to the passive/unpowered
speakers and if it does, the volume will be very low.
Main Power Connection
The power adaptor is in the foam packing material. Unpack the power adaptor
and plug the small end into the DC power jack located at the back side of the
turntable. Plug the power adaptor into your power outlet.
Operation
Turntable Operation
1. Connect the included power adapter to unit and Press the power button
(2) to power ON the turntable.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and place a record on the slipmat. If
using 45 RPM records, put the 45 RPM adapter on the center spindle
before placing the record on the platter.
4. Set the 33/45 RPM Selector according to the type of record.
5. Turn the Start/Stop dial to the Start position to begin spinning the platter.
6. Unlock the arm clip and set the Lift Lever to the up position.
7. Position the tonearm over the desired location (groove) on the record.
8. Move the tonearm lift lever to the down position to move the tonearm
toward the record. Alternatively, place the needle over the desired
location on the record.
9. Carefully lower the tonearm on the record.
10. When you are finished playing the record, raise the tonearm, return it to
rest on the arm clip, and turn the Start/Stop dial to the Stop.
11. Press the power button to turn off the power.
12. The platter will stop turning if there is no signal output from the unit in 3
minutes.
12