LENCO LBT-335 User Manual page 11

2. Pull the anti‐skating weight slightly to let the tie of the fishing line move
to the stub.
3. Lift the anti‐skating weight over the anti‐skating weight wire support. The
anti‐skating weight should now be dangling in free space to the left of
support.
Slip the loop of the anti‐skating weight's thread over the 3nd groove of the
stub to set the correct anti‐skating force for the factory‐fitted cartridge. Feed
the thread through the loop of the wire support.
Anti-skating force adjustment
The anti‐skating force must be adjusted corresponding to the down force as
follows:
Down force
1 ‐ 1.25g
1.25 ‐ 1.5g
Groove in the stub
1 st from bearing rings
2 nd " " "
10