Table of Contents
Advertisement
Brush Roll
The brush roll turns as it sweeps and combs the carpet pile.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the
bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt, Code ZE097
The brush roll belt turns the brush roll to agitate, sweep, and
comb the carpet pile. Check the belt regularly to be sure itis in
good condition. Replace the belt if it stretches, cracks or loses
tension. Cut away any hair or threads wound around the brush
roll or the belt pulley because the buildup could cause the belt
to rotate unevenly.
How To Replace Brush Roll Belt
NOTE:
Turn off the switch and unplug the electrical cord
before replacing belt. Belt pulleys can become hot
during normal use. To prevent injury, avoid
touching the motor shaft when changing the belt.
1. Lower handle to floor to change belt.
2. Remove three screws indicated by screwdrivers in above
illustration. Lift hood to remove.
NOTE: The carpet height adjustment has to be in the lowest
or highest position to remove or reinstall the hood.
Motor
Shaft
Belt
Brush
Roll
3. Lift left end of brush roll.
4. Remove and discard belt.
a
(
=i | 4g
|
Prey
FR ecient
ia
aE
a
6. Place belt around brush roll pulley.
7. Align left end cap with base. Push end cap
securely into place.
8. Pull right side of brush roll to stretch belt.
Secure right end cap into base.
IMPORTANT
9. Rotate brush roll by hand two full
rotations to properly position belt.
10. Place hood back on cleaner. Make sure hood
front is behind furniture guard. Replace three
screws.
11. Tighten screws.
Use GENUINE
Electrolux replacement
belt, Code
ZE097.
13
Advertisement
Table of Contents
