Hyundai i10 Owner's Manual page 401

Emergency situations
NOTICE
Do not let the compressor run for
more than 10 minutes, otherwise the
device will overheat and may be
damaged.
i
Information
The pressure gauge may show higher
than actual reading when the compres-
sor is running. To get an accurate tyre
reading, the compressor needs to be
turned off.
CAUTION
If the inflation pressure is not main-
tained, drive the vehicle a second
time, refer to Distributing the seal-
ant. Then repeat steps 1 to 4.
Use of the Tire Mobility Kit may be
ineffectual for tyre damage larger
than about 0.24 in. (6 mm ).
We recommend that you contact a
HYUNDAI authorised repairer if the
tyre cannot be made roadworthy
with the Tyre Mobility Kit.
WARNING
The tyre inflation pressure should
meet the standard "TYRES AND
WHEELS" in Chapter 2 or "Tyre
Inflation Pressure Standard Label"
If it is not, do not continue driving.
Call for road side service or towing.
8-32
CAUTION
Tyre pressure sensor
(if equipped with TPMS)
The sealant on the tyre pressure
sensor and wheel should be removed
when you replace the tyre with a new
one and inspect the tyre pressure
sensors. We recommend that you
get this done at a HYUNDAI autho-
rised repairer.
i
Information
When reinstalling the repaired or
replaced tyre and wheel on the vehicle,
tighten the wheel lug nut to 11-13
kgf·m (79-94 lbf·ft).