Table of Contents
Advertisement
/ / 'T--'m-'-
nE*D,L,c
nE*D,L,c
5.nnll.V
5.nnll.V
8. ASSEMBLING THE ALTERNATOR (Fig. 23)
8. ASSEMBLING THE ALTERNATOR (Fig. 23)
(1) Support the heat sink or rectifier end shield on
(1) Support the heat sink or rectifier end shield on
circular plate, Tool
circular plate, Tool 813-3377.
(2) Check the rectifier identification to make sure
(2) Check the rectifier identification to make sure
the correct rectifier is being installed. Refer to the
the correct rectifier is being install
i i c c e e p p a a r r ts ts m m a a nu
nua a l l fo for r re rec c ti tif f i i er er i i d d e e nt nti i f f i i c c a a ti tio o n. n.
(3) Start the new rectifier into the casting
(3) Start the new rectifier into the casting squarely
and press the rectifier into the casting with Tool
and press the rectifier into the casting with Tool C C - -
i I i INSE
NSERT RT
\ \
'T--'m-'- I I \ \
' '
L L
TERMINAL
TERMINAL
NYLON
NYLON
\ N A C U FP
\ N A C U FP
1 m
1 m
,.-"a
,.-"a
Fig. 23-Alternator
Fig.
813-3377.
ed. Refer to the serv-
FIER
FIER
23-Alternator Disassembled)
Disassembled)
3772 (Fig. 24).
3772
(Fig. 24).
NOTE:
NOTE:
Clean all
Clean all
(4) Crimp the' new rectifier wire to the wires
(4) Crimp the' new rectifier wire to the wires
connected at removal.
connected at removal.
(5) Support end shield on Tool SP-3383 so that the
(5) Support end shield on Tool SP-3383 so that the
serv-
notc tch h in in su
no
supp
the heat sink and press the bearing into position with
the heat sink and press the bearing into position with
squarely
Tool SP-3381 (Fig. 25).
Tool SP-3381 (Fig. 25).
C C A A L L - - INST
INST RU
RUMENT
MENTS S
/ /
BEARING
BEARING
ROTOR
ROTOR
' '
w w ir es
ir es
ppo o rt rt to tool ol w w il ill l c c l l ea ear r th the e ra rai i se sed d se sec c ti tion
WASHER
WASHER
' '
SCRE
SC
REW W
60xl281A
60xl281A
AEqm ~
AEqm ~
CBS-.
CBS-.
on of of
4 4 3 3
Advertisement
Table of Contents
