Installation - NEC 78K/0 Series User Manual

APPENDIX A INTERFACE BOARD (IE-70000-PCI-IF-A) FOR DESKTOP PC
A.2 Installation
(1) Board settings
There are no jumpers or DIP switches on the IE-70000-PCI-IF-A.
(2) 8-bit connector board mounting
An 8-bit connector board is premounted at shipment.
Remark When a 32-bit board is mounted, place it on the 8-bit connector board using the combination connector
(refer to Figure A-1) and fasten them together.
Caution The 32-bit connector board is attached for future function expansion.
(3) Installation in PC
Make sure that the PC is turned off, then install the interface board in the PCI bus slot following the instructions in
the PC's manual.
(4) PCI driver installation
Refer to the supplied DRV_DISK Readme_e.txt for PCI driver installation.
(5) Connecting with IE-78K0-NS
Using the supplied cable, connect the IE-78K0-NS to the CH0 side.
Caution Connection with the IE-78K0-NS is possible on the CH0 side only.
Figure A-1. Mounting of PCI Board and Connector Boards
Combination connector
PCI board
User's Manual U13731EJ3V0UM
Combination connector
32-bit connector board
Combination connector
CH1 CH0
8-bit connector board
37