DeWalt DXGNi35E Owner's Manual page 32

TROUBLESHOOTING GUIDE
ENGINE WILL NOT START
Possible Cause
Battery not charged.
Engine switch is in the OFF position.
No fuel.
Stale gasoline or water in gasoline.
Engine oil level is low.
Fuel-switch is in OFF position.
Spark plug faulty, fouled, or
improperly gapped.
Engine stored without treating or
draining gasoline, or refueled with
bad gasoline.
ENGINE LACKS POWER.
Possible Cause
Engine stored without treating or
draining gasoline, or refueled with
bad gasoline.
AC RECEPTACLE DOES NOT WORK.
Possible Cause
OUTPUT indicator is OFF, and
OVERLOAD indicator is ON.
AC Circuit protector(s) tripped.
Item plugged in is defective.
If problem persists after trying the above solutions, contact your nearest authorized service center for
assistance.
Solution
Charge battery.
Turn engine switch to the ON position.
Fill fuel tank.
Engine is equipped with Low Oil Shutoff. If engine
Turn fuel-switch to the ON position.
Replace spark plug.
Drain fuel. Refuel with fresh gasoline.
Solution
Drain fuel. Refuel with fresh gasoline. If problem
Solution
Check AC load. Stop and restart the engine. Check
the cooling air inlet. Stop and restart the engine.
Check AC load and reset AC circuit protector(s)
Try a different item.
25