Operation - DeWalt DXGNi35E Owner's Manual

OPERATION

1.
1.1 Turn the Fuel switch to "ON" position.
1.3 Place one hand on the generator to hold it place, and pull on the
recoil starter handle slowly until a slight resistance is felt. Then pull
quickly to start the engine. Returncord gently into the machine.
Never allow the cord to snap back.
Shutting off the generator
2.
2.1
2.2
2.3 Turn the Multi-switch to the "OFF" position to shut down the engine and fuel.
3. Connection Electrical Loads
3.1 Let the engine stabilize and warm up a few minutes after starting.
3.2 Prior to powering tools and equipment, make sure the generator's rated voltage, and amperate capacity
is adequate to supply all electrical loads that the unit will power. If powering exceeds the generator's capacity,
it may be necessary to group one or more of the tools and/or equipment for connection to a separate generator.
3.3 DO NOT connect 3-phase loads to the generator.
3.4 DO NOT overload the generator.
1.2 Turn the START switch and ECO
throttle to the "ON" position.
18