Adjustments; Adjustment Of Inside Height / Griping Range - probst 5310.0372 Operating Instructions Manual

Turf stone laying clamp rgv
Table of Contents

Advertisement

Adjustments

5
Adjustments
5.1

Adjustment of inside height / griping range

The illustraded griping good (Turf Stone) can be gripped in only two adjusting holes (4th hole each from the
inside) for a gripping range/gripping width (GW) of approx. 300 mm and adjusting holes (7th hole each from the
inside) for a gripping range/gripping width (GW) of approx. 500 mm (Fig. 1).
In addition, the "inside height E (Et)" of the grippers on the adapter (4) can be changed, which must be adjusted
depending on the gripping goods to be picked up (Turf Stones) ( Fig. 3).
GW = gripping range/gripping width
Et = inside height E
By adapting the adapters with grippers (4), the
device can be used for lifting different sizes of
gripping goods.
The gripping range/gripping width (GW) is adjusted
as follows:
Place the device on the ground, loosen the wing
nuts (7) and then remove the wing screws (8).
Displace the adapter with grippers (4) until the
gripping range/gripping width (GW) is adjusted to
the gripping good, making sure that both adapters
with grippers (4) are positioned symmetrically (to
the central axis of the device).
Insert the wing screws (8) into the corresponding
adjusting holes and then secure again with wing
nuts (7).
5310.0372
Fig. 1
V2
13 / 20
Fig. 2
GB

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rgv-9/9

Table of Contents