Subscribe to Our Youtube Channel
Related Manuals for probst 5310.0372
Summary of Contents for probst 5310.0372
- Page 1 Operating Instructions Translation of original operating instructions Turf Stone Laying Clamp RGV RGV-9/9 5310.0372...
-
Page 2: Table Of Contents
Maintenance and care ............................17 Maintenance ..............................17 7.1.1 Mechanical ..............................17 Trouble shooting ............................18 Repairs ................................18 Safety procedures ............................19 Hints to the type plate ..........................20 Hints to the renting/leasing of PROBST devices ..................20 5310.0372... -
Page 3: Ec-Declaration Of Conformity
Safety of machinery - safety distances to prevent hazard zones being reached by upper and lower limbs (ISO 13857:2008) Authorized person for EC-documentation: Name: J. Holderied Address: Probst GmbH; Gottlieb-Daimler-Straße 6; 71729 Erdmannhausen, Germany Signature, information to the subscriber: Erdmannhausen, 07.08.2018................ -
Page 4: Safety
Only skilled workers or specialists are allowed to carry out the installation-, maintenance-, and repair work on this device! Skilled workers or specialists must have for the following points (if it applies for this for mechanic device), the necessary professional knowledge. for hydraulics for pneumatics for electrics 5310.0372... -
Page 5: Safety Marking
Each operator must have read and understood the operating instructions 2904.0665 30 mm (and all safety instructions). 2904.0666 50 mm OPTIONAL Be sure that the fork sleeves are mechanically fixed (with locking screw 2904.0223 50 mm and safety chain or rope) to the lifting device/carrier. 2904.0222 80 mm 5310.0372... -
Page 6: Personal Safety Requirements
If there are any cracks, splits or damaged parts on any parts of the device, immediately stop using it. The operating instructions must be available at the workplace every time. Do not remove the type plate of the machine. Unrecognisable information signs (such as regulatory or prohibition signs) must be replaced. 5310.0372... -
Page 7: Safety Procedures
Only authorized and qualified persons are allowed to operate the carrier/lifting device. The operator of the carrier/lifting device must have all the necessary qualifications. Never exceed the maximum allowable carrying capacity/working load limit (WLL) of the carrier/lifting device. 5310.0372... -
Page 8: General
The equipment is suited to the intended operation, the functioning and the working condition of the equipment is examined, and the load is suitable to be handled. Any doubts about instructions should be raised with the manufacturer prior to use. 5310.0372... - Page 9 The gripping and transporting of non-rectangular and round gripping goods, because they could fall down (see figure to the right). Transportation of material with “feet”, “bellies” and “blind spacers”. 5310.0372...
-
Page 10: Survey And Construction
“full” to “empty“ Adaptor with grippers Adjustment of gripping range (W) Technical Data Type: Gripping Range W Working Load Limit WLL Dead Weight depending on adaptors RGV-9/9 300/500 mm (12 – 20”) 250 kg (550 lbs) 20 kg (44 lbs) 5310.0372... -
Page 11: Installation
Load hook and chains Fit suspension ring in the load hook of the lifting device/carrier. Ensure that the single chains strands are not twisted or knotted. Attaching the device to the lifting device/carrier, take care that all local safety regulation is observed. 5310.0372... -
Page 12: Fork Sleeves (Optional)
3 Fork sleeve 4 Chain/rope 4.1.4 Rotators (optional) When using rotators, a free-wheel throttle valve must be installed. In order to prevent a sudden speedup and stopping the rotational movements, as this may damage the device within a short time. 5310.0372... -
Page 13: Adjustments
(4) are positioned symmetrically (to Fig. 2 the central axis of the device). Insert the wing screws (8) into the corresponding adjusting holes and then secure again with wing nuts (7). 5310.0372... -
Page 14: Adjustment Of The Carrying Handle
Remove the carrying handle of the rectangular tube and turn it by 90°. Then reinsert the carrying handle (2) onto the rectangular tube. Insert socket pin (10) again and secure with linch pin (9). Fig. 4 5310.0372... -
Page 15: Operation
Placed over the next product, the automatic release disengages itself and the product can be lifted. The device therefore is a ONE-MAN-MACHINE. Shut-down the device without lifting equipment/carrier only on even ground. The gripping arms must be opened enough, to ensure a secure standing of the device. Otherwise there is a danger of overturning! 5310.0372... -
Page 16: Picture Of The Automatic Release
Otherwise there may be faulty switching and when setting down the load this can cause deformation or damage of the automatic release! The jerky lifting and lowering of the device with and without load. e.g. caused through driving fast with the lifting equipment/carrier over uneven grounds is forbidden 5310.0372... -
Page 17: Maintenance And Care
Check of all the suspension parts, bolts and straps. Check for corrosion and safety by an (at rough conditions shorten the expert. interval) AUTOMATIC-RELEASE Never grease or oil the automatic-release! Clean with high-pressure cleaner when the automatic-release is dirty. 5310.0372... -
Page 18: Trouble Shooting
“Picture of the automatic release”) Change the inset of the automatic release Repairs Only persons with the appropriate knowledge and ability are allowed to repair the device. Before the device is used again, it has to be checked by an expert. 5310.0372... -
Page 19: Safety Procedures
We recommend that after checking the device, the badge “Safety checked” is put on the device. (Order-No.: 2904.0056+inspection sticker with date). You can receive these badges from us. The check by an expert must be proved! Device Year Date Expert Company 5310.0372... -
Page 20: Hints To The Type Plate
Example: Hints to the renting/leasing of PROBST devices With every renting/leasing of PROBST devices the original operating instructions must be included unconditionally (in deviation of the users country's language, the respective translations of the original operating instructions must be delivered additionally)! - Page 21 After each completed performance of a maintenance interval the included form must be fill out, stamped, signed and send back to us immediately 1) via e-mail to service@probst-handling.de / via fax or post Operator: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _...
- Page 22 ÖW klein / narrow ÖW weit / wide 1100 Tragfähigkeit / Working Load Limit WLL: kg / Eigengewicht / Dead Weight: kg / 44,1 Product Name: Turf Stone Laying Clamp RGV-9/9 © all rights reserved conform to ISO 16016 Datum Name Benennung Rasengitter Verlegezange RGV-9/9...
- Page 23 43101154 siehe separate Liste see separate list 43101152 siehe separate Liste see separate list Bei Änderungen Rücksprache TB ! Gewicht: 20,4 kg Schutzvermerk nach DIN 34 beachten! Nachdruck nur mit unserer Genehmigung! Benennung Datum Name Rasengitter Verlegezange RGV-9/9 Erst. 29.8.2013 Ralf.Northe Gepr.
- Page 24 20160004 20100016 20100016 20160004 43101151 20000252 20000017 20000017 20000252 Bei Änderungen Rücksprache TB ! Gewicht: 2,4 kg Schutzvermerk nach DIN 34 beachten! Nachdruck nur mit unserer Genehmigung! Benennung Datum Name Adapter zu RGV-9/9 kpl. Erst. 29.8.2013 Ralf.Northe Gepr. Abstand 400, Et 60 Blatt Artikelnummer/Zeichnungsnummer E43101152...
- Page 25 43100067 20540001 43101335 30320060 20160005 43101149 33100001 20400004 Blatt 2 20060005 20060005 20400004 33100001 43101149 © all rights reserved conform to ISO 16016 43101148 20160005 Datum Name Benennung Rasengitter Verlegezange RGV Erst. 29.8.2013 Ralf.Northe Gepr. Grundgerät ohne Adaptersatz 7.7.2016 R.Hoffmann Tk-250 kg Artikelnummer/Zeichnungsnummer Blatt...
- Page 26 20530065 20000011 20100015 © all rights reserved conform to ISO 16016 40110303 Datum Name Benennung Rasengitter Verlegezange RGV Erst. 29.8.2013 Ralf.Northe Gepr. Grundgerät ohne Adaptersatz 7.7.2016 R.Hoffmann Tk-250 kg Artikelnummer/Zeichnungsnummer Blatt E43101154 Zust. Urspr. Ers. f. Ers. d.
- Page 27 A53100372 RGV-9/9 29040056 29040629 Auf beiden Seiten/On both sides Erstellt/Created: Zuletzt geändert/Last changed: Blatt / Sheet: 1 / 1 06.07.2017 / Krasnikov, Igor 06.07.2017 / Krasnikov, Igor Einige der Abbildungen sind möglicherweise optionales Zubehör des Gerätes/Some of pictures may be optional equipment of the device.
Need help?
Do you have a question about the 5310.0372 and is the answer not in the manual?
Questions and answers