Technical Data - Riello 40 G3 Installation, Use And Maintenance Instructions

TECHNICAL DATA

TYPE
Output
Thermal power
Fuel
Electrical supply
Motor
Capacitor
Ignition transformer
Pump
Absorbed electrical power
Burner with CE marking in conformity with EEC Directives: 2014/30/UE - 2014/35/UE - 2006/42/CE.

The burner meets protection level of IP 40, EN 60529.

8
4
3
1 – Return line
2 – Suction line
3 – Gauge connection
4 – Pump pressure regulator
5 – Vacuum gauge connection
6 – Screws fixing air damper
7 – Hydraulic jack with air damper
8 – Lock-out lamp and reset button
9 – Flange with insulating gasket
2664
23.8 – 35.5 kW
(H
Gas oil, viscosity 4 –6 mm
Single phase, 230 V ± 10%
Run current 0.7 A – 2850 rpm – 298 rad/s
Secondary 8 kV – 16 mA
Pressure: 8 – 15 bar
Fig. 1
7
6
6
9
D6252
HYDRAULIC JACK OPERATION 7)(Fig. 1)
It is strongly recommended a periodic check of
the pump pressure operation (annually or better
every six months, if the burner operation is con-
DANGER
tinuous).
If the value is lower than 1 bar, compared to that
one of the initial setting, please check the clean-
ing of the pump and line filters.
In case the pressure setting was not restorable,
please replace the pump, in order to guarantee
that the pump pressure during the pre-purge time
is at least 3.7 bar.
1
GB
510 T3
2 – 3 kg/h
= 11.86 kWh/kg)
i
2
/s at 20°C
~
4 F
0.115 kW
2
ENGLISH
50Hz
1 5