Operation; Maintenance - Makita CP100D Instruction Manual

OPERATION

CAUTION:
When operating the tool, do not
touch the blade or bring the tool near the hand
or face.
CAUTION:
When cutting the material, never
put the hand in front of the blade.
NOTICE:
Before operating the tool, make sure
that the blades are in the right position as shown
in the figure.
Hold the tool firmly. Turn on the tool, then set the blade
against the material to be cut, and then move the tool
forward.
NOTICE:
Do not apply excessive force to the
tool. It does not help to cut the material smoothly.
NOTE: When cutting the thin material such as fabric,
apply sufficient tension to the material while holding it
and move the tool slowly.
When cutting a disc (CD, DVD, or Blu-ray Disc), tilt it as
shown in the figure to cut it smoothly.
CAUTION:
When cutting materials, be sure
to wear safety glasses to avoid injury caused by
flying debris.
NOTICE:
Do not cut solid plate thicker than CD,
DVD, or Blu-ray Disc, or plate harder than CD,
DVD, or Blu-ray Disc.
When the tool is jammed, rotate it sideways, and then
pull it slowly as shown in the figure.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
7 ENGLISH