Table of Contents
Advertisement
Notes on installation
Installation
Your dishwasher can be installed On any
level and stable floor. It is important that your
dishwasher should stand firmly and horizon¬
tally on the floor. Uneven floor conditions can
be compensated by adjustment of the feet.
If you want to integrate your free-standing
appliance below a worktop, you can remove
the worktop (cover from the dishwasher).
In this case, please make sure that, before
the appliance is inserted, the worktop Is
covered below and on its front edge by an
aluminium foil (to be ordered from
the service centre).
The fitting instructions are given on the back
of this foil.
Only In this manner will your worktop be
protected from damage by the steam
emerging from the machine when the door
is opened.
Important note
(applies only to freestanding machines
with worktop)
If, for reasons of space, there is no alternative
to Installing your dryer directly next to a gas
or electric cooker or coal range, you must
Interpose a thermally insulated panel
(measuring 85 x 57.5 cm) between cooker and
dishwasher. This panel should be coated with
aluminium foil on the side facing the cooker.
If you have build-under appliance, please
follow the notes on installation given in the
Installation and connection instructions
supplied as well as the separate fitting
instructions.
Water supply
This dishwasher is equipped with a safety
valve (solenoid valve) directly at the water tap
(see also page 21); To assure the function of
the safety device, the double-skinned supply
hose must be connected to the outlet valve
(water tap) in a specific installation position.
Please therefore take special note of the
separate "Water Tap Safety Valve"
connection instructions.
Your dishwasher has been built In accordance
with regulations governing water-consuming
appliances and is equipped with safety
devices which prevent used water from
flowing back into the drinking water mains.
Your dishwasher can be connected to either
a cold or hot water supply of max. 6b°C,
but not to open hot water appliances and
through-flow heaters.
The supply hose is fitted with a screwed
hose connection (to DIN 259) and can be
connected to an outlet valve (water tap)
with male thread (y4'').
Suitable washers are supplied with the
machine. Do not use any washers other than
these! The plastic nut of the screwed hose
connections can be tightened by hand.
If you require a supply hose which Is longer
than the one supplied, use only a complete
hose kit continuously and to adequate length.
Never lengthen existing hoses.
19
Advertisement
Table of Contents
