Table of Contents
Advertisement
Notes on installation
Water supply
Important note:
On appliances with a safety valve at the
water tap, the extension can also be made
with a permanently installed copper pipeline
(8—10 mm dia.).
Minimum water pressure:
around 1 bar (1 atm overpressure, 1 kp/cm=i,
10 N/cm*). If your water pressure is under
1 bar, please ask our service centre for
advice.
Maximum allowable water pressure:
around 10 bar. For water pressure over 10 bar,
a pressure reducing valve (obtainable from
your dealer) must be fitted upstream.
Water drainage
The drain hose is fastened at the back
of the machine by a plastic tape.
Remove the plastic tape and place the drain
hose In the plinth recess (see Fig. 31b).
The hose connection (19 mm d|a.) supplied
with the dishwasher will fit all commonly
available makes of sink trap. Secure
the hose with the supplied hose clip.
If you suspended the drain hose on a free¬
standing appliance in a sink, you should then
use the supplied attachable bend
(see Illustration opposite).
If you draw a string through the hole
(see arrow), you can also mount the bend on
a wall and thus prevent it from slipping off
(e.g. if thesink edges are too wide).
20
Advertisement
Table of Contents
