Advertisement
Page 16 of 35
Fixed positions
(A to D) are located on the right side of the selection grid (from the operator's point of
view), and they "force" the mowing deck to maintain the selected height even in the presence of obstacles
or vegetation pushing from the bottom upwards.
Purpose:
Floating positions from 1 to 5 are used to cut a mainly grassy terrain without obstacles or trunks: this way,
the cutting result will have uniform height even in the presence of small depressions, bumps and descents.
Fixed positions from A to D are useful in case of more demanding conditions, when the raw terrain to be
shredded has resistant trunks, shrubs to be bent with force before being shredded, etc. In these positions,
the mowing deck remains in its position and it is not "pushed up" by the obstacles, allowing to shred them
in the best way.
ALL TRANSFERS MUST BE MADE WITH THE LEVER IN POSITION 5 AND WITH THE TOOLS NOT
INSERTED
11 – Rear hydrostatic transmission by-pass lever
bypass ON
PLEASE NOTE: IF THE MACHINE IS ON A SLOPE, DO NOT ENGAGE THE BYPASS!
IMPORTANT: BRING always the lever BACK to the "bypass OFF position" before starting a new work: otherwise,
the machine will not move and the hydrostatic transmission might get damaged!
BEWARE in case the machine is moved by pushing it: do not touch the rear grid while the machine
is still hot, burn hazard!
bypass OFF
Lever [#11] has the purpose of bypassing the
hydrostatic transmission, so to allow machine
movements with the engine off.
To do this, insert the bypass as shown in the
"bypass ON" figure: pull the lever back and lock its
cut to the left to fix it in position.
To return to the work configuration ("bypass OFF"
in the figure), move the lever first to the right and
then push it forward completely.
35451510IT - FOX MINI 85-2WD User and Maintenance Manual
Advertisement
