Connecting To The Origin One 3D Printer - Stratasys ProAero Installation And User Manual

Connecting to the Origin One 3D Printer

Connecting to the Origin One 3D Printer
1. Connect the control cable from the extraction system (shown in
AUX 24V connector in the auxiliary input panel in the lower-left corner of the back of the
Origin One.
2. Remove the cap by lifting it from the exhaust outlet on the top of the printer.
3. Connect the exhaust adapter to the exhaust outlet of the printer, and secure the adapter to
the exhaust outlet with the supplied clamp.
4. Connect the exhaust duct to the adapter on the top of the printer, and secure the duct to the
adapter.
5. Connect and secure the other end of the exhaust duct to the ProAero.
6. In GrabCAD Print, click
the toggle next to Fume Extraction Unit:.
Figure 5: Origin One exhaust vent and power connection panel
Exhaust
outlet
Exhaust
adapter
Control
cable
connector
The vent out of the printing area should be as close as possible to the printing
area without interfering with the 3D printing process, to ensure effective fume
extraction.
next to the Origin One printer, and select Settings. Activate
© Copyright 2023 Stratasys. All rights reserved.
Figure 2 (page 1)) to the
Page 8