Inspecting the System
Inspecting the System
If required by local laws and regulations, this system must be inspected.
Contact Stratasys for more information about inspection and certification.
Cleaning the System
•
Clean the exterior of the system with a damp cloth and non-aggressive detergent.
•
Clean the cooling inlets and outlets once a year to prevent accumulation of dust, and
thereby overheating of the system.
Replacing the Filters
To maintain performance, it is important that you replace the filters with identical replacement
filters. To re-order, refer to the filter number printed on the filter installed in your extraction
system.
Caution:
Do not use an abrasive cleaning product as this will damage the finish.
The ProAero contains a pre-filter pad and a combined filter.
Caution:
To prevent overheating, do not use the system with a blocked filter, or with dust
obstruction of inlets/outlets.
It is recommended to have spare filter(s) on site to avoid prolonged system
unavailability. Part numbers for replacement filters can be found on the filter(s) fitted
in your system.
© Copyright 2023 Stratasys. All rights reserved.
Page 10