Connecting To The 3D Printer - Stratasys ProAero+ Installation And User Manual

Connecting to the 3D Printer

Connecting to the 3D Printer
Several types of adapters are supplied with the system. You connect only the relevant adapters
for your printer type.
Adapter
Insert this onto one end of the flexible duct, and connect the adapter to the
back of the ProAero+.
Note: Secure the metal bands after connecting. Do not remove the 2 smaller
caps on the back of the ProAero+.
For all 350/500 Eden, Connex, and Objet printers: insert the additional
adapter onto the other end of the duct and connect it to the printer exhaust
outlet
Note: Secure the metal bands after connecting. Do not remove the 2 smaller
caps on the back of the ProAero+.
For all J7 series printers and J835/J850 printers: insert this onto the other end
of the duct and connect it to the printer exhaust outlet.
Note: Secure the metal bands after connecting. Do not remove the 2 smaller
caps on the back of the ProAero+.
For all Objet260 and J826 printers: screw this on to the other end of the duct
(counterclockwise) and connect it to the printer exhaust outlet.
A control cable is supplied with the system. This is for future use. Save this for when
this option is available.
© Copyright 2021 Stratasys. All rights reserved.
Used For
Page 6