Table of Contents
Advertisement
|
Symptom
|
Cues
Tape does not wind.
1. Tape is wound to one side.
2. Tape is slacken.
3. Tape
is
unevenly
wound
and
becomes heavy.
Pressing REC does not start recording.
| 1. Erase proof tab is broken.
2. Cassette
holder is not closed com-
pletely.
3. Recording volume is minimum.
Pressing PLAY does not start playing.
1. Wrong connection.
2. Dirty head.
3. Tape
is
unevenly
wound
and
becomes heavy.
4. Tape is not recorded.
Sound becomes
hoarse
or loss of high
tone.
1. Dirty head.
2. Tape is stretched and out of shape.
1. Recording volume was too high while
recording.
2. Source has a warp.
Loud noise.
1. Head is magnetized.
2. Outside noise.
3. Recording level is low.
4. DOLBY NR is off when playing a tape
recorded with DOLBY NR.
Sound vibrates.
1. Dirt,on the capstan or pinch roller.
2. Tape is not wound evenly.
1. DUBBING switch is set to ON.
2. DUBBING switch is set to ON and A
Remedy
1. Rewind tape or reverse it.
. Take up the slack with a pencil.
. Change tape.
. Provide a tape with the erase proof
tab (tape over the erase proof notch).
. Close the holder completely.
. See "How to Record" on page 8.
. See "CONNECTIONS" on page 3.
. See "Easy Care" on page 23.
. Change tape.
. Set a recorded tape.
Qh
BWND
=
|
1. See "Easy Care" on page 23.
2. Change tape.
See "How to Record" on page 8.
1. Use a head eraser.
2. Separate
from
other
electrical
appliances.
. See "How to Record" on page 8.
. Turn on DOLBY NR.
Setting
DOLBY
NR
to ON during
recording, is recommended.
. See
"Cleaning
Around
Head"
on
page 23.
. Wind
the
tape
again
using
FAST
FORWARD or REWIND.
. Set the DUBBING switch to OFF.
. Stop A deck.
Sound will not come from B deck.
Malfunction of DPSS.
Slight difference
in the ending of A and
B decks during dubbing.
deck is in playback mode.
DUBBING switch is set to ON and A deck
is in playback mode.
Tape used is not suitable for DPSS such
as a short blank section between selec-
tions.
Because of uneven length of tapes and
the mechanism. characteristics
of the
decks.
Door
cannot
be opened
by pressing
EJECT.
Door does not open when EJECT is
pressed during recording or playback.
Does not operate when operation keys
are pressed.
The button is pressed during recording
. Keys are pressed within 3 seconds
after turning power on.
. Tape is not loaded.
. Tape
is
wound
unevenly
and
becomes heavy.
Set the DUBBING
switch
to OFF and
stop A deck.
See "DPSS" on page 13.
A
slight
difference
will
not
cause
Stop
the recording
or playback
then
press EJECT.
1. Press operation keys for 3 seconds or
more after turning power on.
2. Load a tape.
3. Change tape.
Caution:
Avoid using 120 minute tapes because they are too thin, stretch and become out of shape amplifier.
24)
x7wx U)
Advertisement
Table of Contents
