Kenwood TS-950SDX Instruction Manual page 46

4-7-4. Continuous Playback
When MENU No.24 is on, REC-3 will provide
continuous (loop) recording of 8 or 16 second
intervals of receiver audio. At this time the REC-
3/PLAY-3 key is fixed as the REC-3 key and the
VOICE key function as the PLAY-3 key.
1. Turn on MENU No. 24
2. Press the REC-3 key.
The REC-3 starts recording the receiver audio.
After 8 seconds, new information is recorded over
the previous one. The recording time can be set
to 8 or 16 seconds using MENU No.25.
If you want to save an 8 or 16 seconds segment
of the recording, press the REC-3 key. This will
transfer the recording into a buffer memory.
To play back the saved recording, press the
VOICE key.
4-7-5. Repeat Playback
When MENU No.26 is on, recorded information is
repeatedly played back. To stop playback , press the
CLR key.
Example: If PLAY-1 is pressed, the PLAY-1
recording is repeatedly played back until
the CLR key is pressed.
Example: If PLAY-1 PLAY-2 and PLAY-3 are
pressed, all three recording are
repeatedly played back until the CLR key
is pressed.
Note
| You must stop continuous recording or repeat
| playback before shutting the transceiver off or the
| recording could be erased.
Menu No.27 allows the repeat playback interval to
be set within the range from O to 60 seconds. (Initial
setting: 10 seconds)
Example: If the interval is set to 20 for the
playback of PLAY1 only, the PLAY1
recording is played back repeatedly with
a 20-second intermission following each
PLAY1 playback.
46