Kenwood TS-950SDX Instruction Manual page 40

is found and displayed, press the M.IN key again.
iw
The current frequency and mode will be stored,
the Memory Scroll mode
will be canceled, and
the transceiver will return to the operating mode
and frequency
that was
displayed
before the
M.IN key was pressed initially.
These memory channels can have a variable
range like another VFO by storing the upper and
lower frequency limits in memory. The frequency
is varied with the Tunning Knob.
4-4-6. Memory Channel Recall
T
he following procedure describes how to recall a
memory channel.
1. Select memory channel operation for either RX
or TX by simply depressing the appropriate
FUNCTION keys. The display will indicate the
frequency of the memory channel you used last.
. You can select a different memory channel by
rotating the M.CH/VFO CH control. The memory
channel
indicator and
the frequency
in the
appropriate display will change as this control is
rotated.
4-4-7. Memory Channel Scroll
Ti
check a Memory Channel
he following procedure provides a method to
Frequency without
changing or losing the current receive frequency.
1.
4
Press the M.IN key once to initiate Memory
Scroll. The M.SCR indicator lights, and the
Memory Channel Frequency is displayed.
Although the displayed frequency will change,
actual reception will be at the previous
frequency (that is, the frequency before the M.IN
key is pressed).
. Select a Memory Channel using the M.CH/VFO
CH control or numeric keys. The frequencies
stored in the Memory Channel! will be displayed.
the CLR key.
-4-8. Transferring Memory Information
to the VFO
The following procedure transfers the contents of
the selected memory channel to the VFO.
1.
2. Press the M — VFO key. This will cause the
contents of the memory channel to be
transferred to the unused VFO position.
40
a)
Pressing the M—>VFO key will shift the memory
channel data to VFO A when using a standard
memory channel.
Pressing the M— VFO key will cause the RX
frequency to be shifted into VFO A and the TX
frequency to be shifted into VFO B when using
a Split Frequency Memory Channel.
Pressing the M—VFO key will cause the memory
channel data to be transferred to the unused
VFO when using a memory channel for RX or TX
and a VFO channel for the other function.
N
1.
otes
When the M—VFO key is pressed, the contents ;
of the VFO are cleared but the contents of the
Memory Channel wil! not be cleared.
Channel, only the channel number is displayed;
no transfer is carried out.
. if nothing is stored in the selected splayed
4-4-9. Checking the Highest and Lowest
It
Scan frequencies
is possible to check the frequencies that are
us
1.
2.
3.
ing the following procedure.
Select M.CH operation for RX.
scan limit.
. If you decide after viewing that you wish to
utilize this scanning range simply press the
M->VFO key to transfer the data to the VFO, and
then press the SCAN key.
4-4-10. Mode and Filter Changes during
Memory Channel! Operation
ch
transmit / receive frequencies,
4-4-11. Clearing a Memory Channel!
To erase a specific Memory Channel, press and hold
the CLR key for approximately 2 seconds.