Kenwood TS-950SDX Instruction Manual page 11

D a 4o)
el
g ass | F Lock oara eeg
dees Fee a
aoe Tie (ar we
feta) Gi ii, a, O:
Ce o iye ago
A w eii
DORITI
@ Meter
During receiving of signals the meter is used as an
S-meter. During transmission the meter is used as a
POWER meter, and is controlled by the METER
switch, and provides either VSWR, COMP level, ALC
level, or Ic meter readings.
Notes
1. Simultaneous reading of SWR and COMP level
is not possible.
2. Simultaneous reading of ALC level and Ic is not
possible.
3. Simultaneous reading of more than three data |
items is not possible. i
4. The bottom scale functions as an S-meter for
the Sub-band during Sub-band receive j
operations.
© Filter indicators
Indicate which filters have been selected. Works for
Main or Sub-band depending on the setting of the
M/S switch @ .
@ F.LOCK display
Lights when the F.LOCK key is ON.
DATA display
Lights when the DATA MODE is ON.
PRG (Program) display
Lights during selection or operation on
memory channels 90 to 99.
SCAN display
Turns ON during scanning.
M.SCR (Memory scroll) display
Lights when the M.IN key is pressed. When the
memory scroll function is active, you can
review the contents of the memory channels
without a loss of the incoming receive
frequency.
RIT display
Turns ON when using RIT.
XIT display
Turns ON when using XIT.
* display
Turns ON when using FINE.
M.CH (Memory channel) display
Turns ON during a Memory Channel
operation.
49 <A> display
Lights when VFO A is selected and shows that
the VFO is operating.
<B> display
Lights when VFO B is selected and shows that
the VFO is operating.
<M> display
Lights when a memory channel is selected and
shows that the Memory function is operating.
a) SPLIT display
Turns ON during split operation.
TF-W (TX Frequency Watch) display
Turns ON during TF-W operation.
& ON AIR indicator
Lights during transmission.
B Analog Scale
Shows the frequency selected. Full scale can be
switched to either 1 MHz or 100 kHz depending on
the function setting when the power switch is
turned on. (See section 4-2-13.)
@ AT TUNE (Antenna Tuner) indicator
Lights to show that the automatic antenna tuner is
in operation. When it is lit, do not attempt to
operate further until it goes off.
® Frequency display
Indicates the operating frequency.
dé AIP(Advanced Intercept Point) indicator
Lights when the AIP switch is ON.
®© SUB indicator
Lights when the SUB receiver is turned on by the
SUB key, then the M/S key is pressed.
11