Kenwood TS-950SDX Instruction Manual page 23

4-2-8. Dual Digital VFO's
A=B key
Pressing this key resets the data of the inactive
VFO (frequency,
mode
and
filter settings
currently displayed}
to the
data of the
active
VFO.
Note
When a memory channel is being used for
reception, the A=B key will not function.
For example:
4-2-9. Direct Keyboard Frequency Entry
| Note
You cannot enter any frequency which is outside |
the coverage of the transceiver.
1. Press the ENT key. The following display will
appear.
2. Enter the desired operating frequency down to
the arbitrary digit. You do not have to enter
trailing zeros, but you must enter leading zeros.
a ee ae
For example:
To enter 14.200 MHz, there are two methods:
Method one: Press [ENT], [1], [4], [2], [ENT]
Method two: [ENT], [1], [4], [2], [0], [0], (0], [0]
11 fa} ie] few
4. lf you make a mistake while entering the
frequency and have not yet pressed the ENT key,
or entered
the final digit, you may
cancel the
input by pressing the CLR key.
4-2-10. CW Zero-beat Operation
1. Turn the MONI switch to OFF.
3. A side tone will be heard from the speaker.
23