Kenwood TS-950SDX Instruction Manual page 45

4-7. VOICE RECORDING USING DRS
FUNCTION
(When the optional DRU-2 digital
recording unit is installed)
When the optional DRU-2 is connected to the
transceiver, microphone audio can be recorded in a
manner very similar to the CW message function.
E MENU No.23
Changing the recording time
1. Press the MENU key.
2. Adjust the M.CH/VFO CH control to select menu
number 23. The SUB frequency display will then
show the initial setting.
8-16 : RECI / REC2 / RECS = 8/8/16
seconds
16-32: REC1/REC2/REC3 = 16/16/32
seconds
3. Use the UP/DOWN switches to select the desired
setting.
4. Press the MENU key again to complete this
MENU operation.
4-7-1. Recording Method
The message to be transmitted is recorded with your
normal microphone.
1, Select the desired mode.
| Note
| This function is disabled during FSK and TUNE
! operations. |
2. Set the VOX/MAN switch to MAN.
3. Set the REC/PLAY switch on the quick keyboard
to REC.
4, Press REC1, REC2, or REC3.
Example: When RECI is pressed.
5. Press the same REC key again. Recording occurs while
the key is held down (Initial setting: REC1 ; 8 seconds,
REC2 : 8 seconds, RECS : 16 seconds}
Example: pressing the REC1 switch.
oo raw
jee (Lee
07-+06->06....00
6. To stop recording, release the REC key.
This returns the DRU-2 to the previous operating
state.
Notes |
1. If the CLR key is pressed during recording the
contents are all erased. !
2. tf the recording time elapses during recording,
the DRU-2 automatically stops recording and |
| returns to the previous operating state.
4-7-2. Playback Method
. Set the receive mode.
2. Set the VOX/MAN switch to MAN.
3. Set the REC/PLAY switch on the quick keyboard
to PLAY.
4, Press the PLAY key corresponding to the REC
key used for recording, so that the DRU-2
reproduces the sound.
Example: To reproduce the sound recorded with
the REC1 key, press the PLAY1 key.
=
= oe = sy
5. For continual playback, press the same or another
PLAY key during playback.
The playback of up to three recordings can be
programmed,
When the standby number field displays a dash
(—) the DRU-2 accepts the next PLAY key.
Example: Pressing the PLAY2 and PLAY3 keys
in succession during PLAY1 playback.
[qo pa |
6. Use the MONI control to adjust the volume.
When the playback is completed, the DRU-2
returns to the previous operating state.
4-7-3. Transmitting a Message
H In the receive mode
1. Set the VOX/MAN switch to VOX.
2. Press the PLAY key for the desired channel to
start transmission. For information about the
microphone gain adjustment, see the SSB or AM
transmission section.
3. When the transmission is complete, the receive
mode will return automatically.
While the microphone is not operated during VOX,
leave the GAIN control turned fully
counterclockwise to prevent recorded voice
transmission from being affected by the delay
time.
E in the transmit mode
Press the PLAY key for the desired channel to start
transmission.
45