Pioneer SX-2300 Operating Instructions Manual page 8

SETTING THE UNIT PRIOR TO OPERATION
@) TUNING switches (DOWN, UP)
UP: The FM or AM band is scanned in the direction of increas-
ing frequency.
DOWN: The opposite operation to that of the UP switch
takes place.
@ Tape monitor switch
(TAPE 2] — Press when listening to tape playback with a
tapedeck.
@ FUNCTION switches
Use to select playback source.
[TAPE 1/DAT] — Press when listening to tape playback with
a cassette tape deck or digital audio tape deck.
[VCR/LINE] — Press when listening to programs frarn a com-
ponent connected to the VCR/LINE terminals.
{CD] — Press when listening to compact disc playback with
a CD player.
[TUNER] — Press when listening to AM or FM broadcasts
with a tuner.
[PHONO] — Press when listening to record playback on a
turntable.
@ VOLUME control
Use to adjust volume level.
BALANCE control
Should normally be left in the center position. Adjust balance
if the sound is louder from one of the speakers. If the right
side is louder, turn toward the LEFT position and if the left
side is louder, turn toward the RIGHT position.
SETTING THE UNIT PRIOR
GRAPHIC EQUALIZER controls
The equalizer is divided into five frequency ranges (100 Hz,
330 Hz, 1 KHz, 3.3 kHz, 10 kHz) to tailor music to the in-
dividual taste of the listener.
@) Band Selector switches
These switches are used to select either AM or FM reception.
AM: Push this switch for AM reception.
FM; Push this switch for FM reception.
G3) OPERATION DISPLAY panel j
{a} Indicates the function selected —(f} FM STEREO indicator
by the function switches: oes
{g) AUTO tuning indicator
(b) Indicates frequency or channel
(STATION CALL number).
(c) SURROUND indicator {i} TUNED indicator
(h) FM MONO indicator
{d) SIMULATED STEREO indicator
{e) TAPE monitor indicates
(a)
eee eaEee
Robaina
Cees
PUP
ULGI wg
CEEEZ) —(e)
Pom oc a
vn em ee re Sa fh
L
a aie
{b)
TO OPERATION
@ Before operating the unit, be sure to set it as shown below.
Set the volume control
to the "0" position.
Set the BALANCE control
to the center position. i
Press the SPEAKERS switch
corresponding to the speaker
system to be used.
8
<ARB1094>
Set the TAPE 2 switch to OFF
(TAPE 2 indicator goes off).