Pioneer SX-2300 Operating Instructions Manual page 7

The illustration shows mode! SX-2300.
$X-1300 only
2 eS =| c=s
@) POWER switch
When this switch is pressed, power is supplied to the unit.
Press the switch again to turn power off.
@ SPEAKERS switches (MOFF, mON)
These are used to select the speaker through which you wish
to listen.
A: When the speakers connected to A terminals are in use.
B: When the speakers connected to B terminals are in use.
¢ Turn both A and B speakers to OFF position when only the
HEADPHONES are inuse.
NOTE: (SX-1300 only}
No sound will be heard through the speakers when both A
and B switches are depressed if only one set of speakers has
been connected to either A or 8B SPEAKERS terminals.
(@ SURROUND selector switch (SX-2300 only)
By pressing the A and B SPEAKERS switches, then pressing
this switch ON, you can obtain surround reproduction. If you
press this switch OFF again, normal reproduction from both
speakers A and B will be obtained.
@ PHONES jack
Connect the plug on your headphones to this jack. To listen
to a program through the headphones, set both SPEAKERS
A and B switches to the OFF position.
&) SIMULATED STEREO switch (SX-2300 only}
This turns monaural signals into simulated stereo sound. Use
this when you wish to experience the sense of stereo pres-
ence with AM broadcasts, VCR or other monaural signal
sources.
NOTE:
This function can also be used with stereo sources, but it wilf
result in a different sound from the normal stereo sound.
(©) MEMORY SCAN switch
Press this switch to scan the stations in the memory.
@) FM MODE AUTO/MONO selector switch
Use to select the auto stereo mode or monaural mode when
listening to FM broadcasts. The monaural mode has been
selected when the FM MONO indicator is lighted.
'Auto stereo mode:
Normally leave in this mode for reception. When a stereo FM
broadcast is received, it will be automatically reproduced in
stereo sound.
Monaural mode:
When receiving distant stations or stations with weak broad-
cast signals, the input signal may be weak, thus resulting in
increased noise during FM stereo broadcasts. In this event,
setting the receiver to the monaural mode will reduce the
noise. In this case, however, FM stereo broadcasts will be
reproduced in monaural sound.
NOTE:
This switch has no effect on reception of AM broadcasts.
@ TUNING AUTO/MANUAL switch
Works during FM reception.
Use this switch to select either the AUTO mode or the
MANUAL mode.
When the "AUTO" indicator is lit, the receiver is in the AUTO
mode. (See page 9}
@) MEMORY switch
This is used to memorize stations. When the switch is
pressed, the frequency indicator will flash. To memorize the
frequency of any station, press the STATION CALL switch
while the frequency indicator is flashing. (See page 10.)
STATION CALL switches
These switches are used to preset and recall desired broad-
casting stations.
z
<ARB1094>>