Screen Sleep; Modbus Parameter Configuration; Ao Register List - Ebyte ME31-XXXA0006 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
setting item.
Save parameter settings and restart: After setting the parameters, move the cursor to save and restart, then
short press the confirmation key to enter the confirmation save and restart state. Short press the confirmation key
(press other keys to exit the confirmation state) to save the parameters and restart the device.
Exit without saving parameters: move the cursor to exit, then short press the confirmation key to enter the
confirmation exit state, short press the confirmation key (press other keys to exit the confirmation state), and then
exit the parameter configuration interface without saving the parameters .
Among them, the data bit and stop bit cannot be set. After the DHCP mode is turned on, the local IP address,
gateway, and subnet mask cannot be configured and are only assigned by the router;

4.4.4. Screen Sleep

The device screen has a sleep function, which is off by default and can be set to on in the configuration
interface.
In any interface, when there is no button operation for 180 seconds, the screen will enter the sleep mode. At
this time, the interface displays Ebyte robot. Press any button can exit the sleep mode.
When the screen is in sleep mode, the running efficiency of device programs will be improved.

4.5 MODBUS parameter configuration

4.5.1. AO Register List

Register function
Analog output
value
Analog output
value
AO output mode
AO power-on
output initial value
Copyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
Register Register
address type
Holding
0x0000
register
Holding
0x0064
register
Holding
0x0514
register
Holding
0x00C8
register
Number Operate Data Range/Remarks
32-bit
12 RW
type, unit mA
Analog channel output
6 RW quantity, 2-byte integer,
unit (uA)
AO
range
6 RW
0x0000: 0~20mA
0x0001: 4-20mA
Output
quantity
analog
12 RW
powered on, a 4-byte
floating point number,
the default is 0
ME31-XXXA0006_UserManual_EN
Related
function code
floating point R：0x03
W：0x10
R：0x03
W：0x10
channel output
R：0x03
W：0x06、0x10
engineering
when the
channel is R 0x03
W 0x10
18