Page 4
( QtY = G ap between floor and end panel #94-132 5/16" Plusnut Spacer 4× 4× 0.375" ID, × 1.0" OD × 0.25" LONG # 98-157 NYLON For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 4...
NOTE: Do these on both sides of the van. TOOLS q Cordless Impact or Ratchet q Philips Screw Driver q 7/16" Socket For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 7...
Mark 2 holes of each end panel on the vehicle floor. NOTE: If you are using Ranger floor, please go to paGe TOOLS q Marker MARK For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 9...
1/2" Drill Bit w/ Drill Collar ( Set at 1/2" ) q Plus Nut Tool ( 5/16" ) HARDWARE USED 8× #94-132 Plus Nut DRILL COLLAR 1/2" ) set at For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 10...
Page 11
1/2" socket until the plusnut locks, then remove the bolt by turning the impact in reverse. FORWARD REVERSE For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 11...
( QtY = G ap between floor and end panel #94-132 5/16" Plusnut most vehicle use spacer when not over ribs W/ Spacer W/O Spacer For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 12...
Page 16
“You have successfully installed your P4-RS60-3 Thank you for doing business with us. ” cs@rangerdesign.com For any feedback or suggestions you may have, please contact: For technical support, contact us at 1-800-565-5321 P4-RS60-3 Installation Guide | REV. B2 | Page 16...
Need help?
Do you have a question about the P4-RS60-3 and is the answer not in the manual?
Questions and answers