Advertisement
Quick Links
®
Ezy-Drink
Remote Bubbler Tapware
PRODUCT CODES:
- TD45C
- TD90C
SPECIFICATIONS
−
Drinking taps are designed to operate at full mains pressure.
−
Rubber and metal mouthguards are designed to help protect teeth when drinking.
−
Rubber mouthguard is resistant to fungal and bacterial attack and has a high resistance to sunlight.
−
Vandal resistant handle.
−
Adjustable built-in flow restrictor.
IMPORTANT: All Ezy-Drink
premises in good working order.
TECHNICAL DATA
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Maximum Working Temperature (°C)
Nominal Flow Rate (LPM)
Finish
NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice.
PRE-INSTALLATION
MOUNTING DETAILS – HOLE CENTRES
−
TD90C - If the mounting holes do not already exist, mark
out and drill the holes in the wall/sheet, as shown in
rough-in dimensions.
Note: Before installation, all lines must be flushed. We
recommend that a line strainer be installed prior to drinking taps
to eliminate any foreign material.
TOOLS REQUIRED
−
Power drill
−
Spanner or adjustable crescent
−
Screw driver
®
Remote Bubbler taps are tested in accordance with AS/NZS 3718 and leave our
Version 1, 31 October 2016, Page 1 of 4
15BSP - Female
Rubber / metal mouth guard
Cam Action
Min
50
Max
500
Min
5
Max
70
4.5
Chrome
50.5
TO SUIT
SCREWS
USED
Advertisement
Related Manuals for Galvin Specialised Ezy-Drink TD45C
Summary of Contents for Galvin Specialised Ezy-Drink TD45C
- Page 1 Maximum Working Temperature (°C) Nominal Flow Rate (LPM) Finish Chrome NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice. PRE-INSTALLATION MOUNTING DETAILS – HOLE CENTRES − TD90C - If the mounting holes do not already exist, mark 50.5...
- Page 2 Version 1, 31 October 2016, Page 2 of 4 INSTALLATION IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
- Page 3 Version 1, 31 October 2016, Page 3 of 4 TROUBLESHOOTING PROBLEM CAUSE RECTIFICATION Inconsistent flow Blocked top assembly Remove top assembly and clean Water is turned off Turn on water Water is not flowing from tap Blocked flow restrictor Remove restrictor and clean Top assembly loose or internally Remove top assembly, clean with water Continuous flow...
- Page 4 Version 1, 26 October 2016, Page 4 of 4 WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering Pty.