Owner Responsibility; U.s. Epa Emissions Limited Warranty; Emission Control System Components - Mercury 350 Scorpion ECT MerCruiser Operation & Maintenance Manual

Section 1 - Warranty
ECI Label
EMISSION CONTROL INFORMATION
THIS ENGINE DOES NOT COMPLY WITH U.S. EPA NONROAD EMISSION
REQUIREMENTS. SELLING OR INSTALLING THIS ENGINE FOR ANY
PURPOSE OTHER THAN TO REPLACE A NONROAD ENGINE BUILT
BEFORE JANUARY 1, 2010 MAY BE A VIOLATION OF FEDERAL LAW
SUBJECT TO CIVIL PENALTY.
SERIAL #: XXXXXXXX
FAMILY: XXXXXXXXXXXX
HC+NOx FEL : XX.X g/kWh

Owner Responsibility

The operator must have routine engine maintenance performed to maintain emission levels within prescribed certification
standards.
The operator may not modify the engine in any manner that alters the horsepower or allows emissions levels to exceed factory
specifications.

U.S. EPA Emissions Limited Warranty

Consistent with the obligations created by 40 CFR Part 1045, Subpart B, Mercury Marine provides an emission warranty of
three years or 480 hours of engine use whichever occurs first to the retail purchaser, that the engine is designed, built, and
equipped so as to conform at the time of sale with applicable regulations under section 213 of the Clean Air Act, and that the
engine is free from defects in materials and workmanship which cause the engine to fail to conform with applicable regulations.

Emission Control System Components

The emission‑related warranty covers all components whose failure would increase an engine's emission of any regulated
component including the following list of components:
1. Fuel metering system
a. Carburetor and internal parts (or fuel pressure regulator or fuel injection system)
b. Air/fuel ratio feedback and control system
c. Cold start enrichment system
d. Intake valves
2. Air induction system
a. Controlled hot air intake system
b. Intake manifold
c. Air filter
d. Turbo charger systems
e. Heat riser valve and assembly
3. Ignition system
a. Spark plugs
b. Magneto or electronic ignition system
c. Spark control system
d. Ignition coil or control module
e. Ignition wires
4. Lubrication system
a. Oil pump and internal parts
b. Oil injectors
c. Oil meter
5. Positive crankcase ventilation (PCV) system
a. PCV valve
b. Oil filler cap
6. Exhaust system
a. Exhaust manifold
b. Exhaust elbow
Page 8
DOM: MMM YYYY
DISP: X.XL :
POWER XXX kW
CO FEL : XXX g/kWh
Standard of Compliance
Indicates a service marine engine that can replace a marine
engine built prior to January 1, 2010.
0575
43499
90-8M0099729 NOVEMBER 2014
eng