Lan; Wireless Lan - Toshiba Qosmio G10-105 User Manual

Toshiba qosmio g10-105: user guide
Table of Contents

Advertisement

Problem
After making a call you
can't hear a ring
Communication is cut
off unexpectedly
A CONNECT display is
quickly replaced by NO
CARRIER
Character display
becomes garbled
during a
communication
You cannot receive an
incoming call

LAN

Problem
Cannot access LAN
Wake-up on LAN does
not work

Wireless LAN

If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4,
Problem
Cannot access
Wireless LAN
User's Manual
Procedure
Make sure the tone or pulse selection in your
communications application is set correctly.
You can also use the ATD command.
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
Check the error control setting in your
communications application.
You can also use the AT\N command.
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
Check the rings before auto answer setting in
your communications application.
You can also use the ATS0 command. If
problems persist, contact your dealer.
Procedure
Check for a firm cable connection between the
LAN jack and the LAN HUB.
Make sure the AC adaptor is connected. The
Wake-up on LAN function consumes power even
when the system is off.
If problems persist, consult your LAN
administrator.
Operating
Basics.
Procedure
Make sure the computer's wireless
communication switch is set to on.
If problems persist, contact your LAN
administrator.
Troubleshooting
10-16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pqg10c-gp202eQosmio g10

Table of Contents