Changing Channels Of The Recorder Using The Remote - Sony RDR-GX330 Operating Instructions Manual

Select "Others," and press ENTER.
SETUP
Select"CommandMode,"andpress
ENTER.
SETUP
To check the Command Node for the
recorder
Press • STOP on the recorder when tile
recorder is turned off. Tile Command Mode
l\_r the recorder appears in the front panel
display.
ll the C()mmand Mode for the recorder has
not been changed, set tile CommaM Mode
for Ihe remote lo lhe delault setling ol
DVD3. If Ihe Command Mode lk)r the
remole is changed to DVDI or DVD2, you
will be unable lo operale this recorder.
6
7
Selecta Command Mode(DVD1,
DVD2,or DVD3),andpressENTER.
Set the Command Node for the remote
so it matches the Command Mode for
the recorder you set above.
Follow the steps below to set the
Command Mode on the remote.
(!) Hold down ENTER.
@ While holding down ENTER, enter
the Command Mode code nunlber
using the number buttons.
Command Mode Code number
DVD] nulllber button l
DVD2 number butten 2
DVD3 number button 3
@ Hold down both the number and
ENTER buttons at the salne time for
more than three seconds.
You can change channels of file recorder
using the number buttons.
Number
buttons,
SET
Example: lot channel 50
Press "5," "0," fl3enpress SET.
22