Sony RDR-GX330 Operating Instructions Manual page 86

There is not enough disc space for the
recording.
A separate recording was in the process of
being made without tile use of tile timer
(page 47).
Tile recorder was in tile process of DV/
Digital8 Dubbing.
Recording does not stop immediately
after you press • REC STOP.
It will take a few seconds fur the recorder to
input disc data belk_re recording can stop.
Recordingdoesnot stopafter you press
• STOP.
Press • RE(! STOP.
The recorder is commcted to the TV output
jack
of tile connected equipment.
Synchro-Recording d oesnotcomplete.
The timer setting fur the connected
equipment overlapped the recorder's timer
setting (page 48).
There was a power f:dlure during the
recording.
The recorderautomatically starts
recordingwhen the satellite receiver is
turned on.
The S_ochro-Rec function "_asactivated.
Turn off the satellite receiver and cancel the
Synchro-Rec function (page 47).
Timerrecording isnotcomplete o rdidnot
startfromthe beginning.
There "_as a po'_ er f:,ilure during recurding.
If the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power f:,ilure continue fur more
than I hour. reset the clock (page 72).
Disc space was not enough.
Contents previously recordedwere
erased.
Data that isnot playahle ou this recorder hut
was recorded on a DVD with a PC will be
erased from the disc when the disc is
inserted.
Nothing was recorded even though you set
the Synchro-Rec setting correctly.
You lorgot to turn off tile ccmnected
equipment. Turn off the comlected
equipment and set the recorder to Syuchro-
Rec standby mode (page 47).
The recorder was not set to the Synchro-
Recording standby mode. Press
"1 • SYNCHRO RE(! to have the recorder
stand by for recording. Make sure the
SYNCHRO REC indicator lights up on the
front panel (page 47).
The equipment is not connected to the LINE
I IN jacks of the recorder.
The clock has stopped.
Set tile clock again (page 72).
The clock stopped due to a power failure
that lasted for more than 1 hour. Reset the
clock (page 72).
The TIMER REC indicator is flashing.
The disc does not have enough space.
Insert a recordable disc inside the recorder.
The inserted DVD is protected (page 35).
The recording mode indication is
incorrect.
When tile recording or dubbing is less than
ten minutes, or if a picture with little
movement is displayed for more than ten
minutes, the recording mode indication may
be displayed incorrectly. Note that the
actual recording or dubbing itself was
correctly made in the selected recording
mode.
After playing titles recorded in EP and SLP
mode. the recording mode indication may
change depending on the recorded program.
The clock does not appear in the front
panel display when the recorder is turned
off.
"Power Save Standby" in tile "Others"
setup is set to "On" (page 81), and the
recorder is in standby mode.
86