Table of Contents
Advertisement
Installation
Note:
Before finally installing the unit, connect
the wiring temporarily and make sure it
is all connected up properly and the unit
and the system work properly.
Consult with your nearest dealer if
installation requires the drilling of holes
or other modifications of the vehicle.
Install the unit where it does not get in
the driver's way and cannot injure the
passenger if there is a sudden stop, like
an emergency stop.
When mounting this unit, make sure
none of the leads are trapped between
this unit and the surrounding metalwork
or fittings.
lf Hide-away unit is installed in the
passenger compartment, anchor it
securely so it does not break free while
the car is moving, and cause injury or
an accident.
If Hide-away unit is installed under a
front seat, make sure it does not
obstruct seat movement. Route all leads
and cords carefully around the sliding
mechanism so they do not get caught or
pinched in the mechanism and cause a
short circuit.
If you are not going to affix the front
panel to the mounting base with a
screw (so you can detach the front
panel), be sure that the control unit is
mounted at an angle no greater than 30°
from level. If it is attached at an angle
greater than 30° the front panel may fall
out of the mount, or the detach feature
may not work correctly. (Fig. 7)
30°
Fig. 7
Installing the Control Unit
Disassembling the Control Unit
1. Refer to "Using the Removable Front
Panel" on page 12 to remove the front
panel.
(After installing the mounting base to
the vehicle, install the front panel to the
mounting base.)
2. Remove the frame and holder from the
mounting base. (Fig. 8)
Holder
/
Mounting base
Fig. 8
Frame
Advertisement
Table of Contents
