Table of Contents
Advertisement
Setting the Head nit
Parts Identification
Fig 1
{1]
Volume buttons
Fig. 3
[16] Sound clip indicator
When this unit is connected to the head
unit, the volume, balance and fader can be
adjusted with this unit. Before operating
this unit, set the head unit as follows.
1. Press the (-) side of buttons [1] to set
the volume of the unit to "V 0".
2. Set the volume of the head unit to
"VOL 23".
3. Set the fader and balance of the head
unit to center position.
*
To adjust the volume, fader and balance
on the head unit, refer to the Owner's
Manual that accompanies the head unit.
16
Note:
When the head unit volume is excessive
(excessive input to the unit), "CLIP" [16]
will be indicated on the display as a
warning. In this case, turn the volume
on the.head unit down to the point
where "CLIP" is no longer displayed.
When you feel a distortion in the sound
even though "CLIP" is not indicated on
the display, turn the volume on the
head unit down.
The volume's set point is not indicated
on the display when you adjust the
volume on the head unit by tuning the
volume control.
In this case, set the
volume control on the head unit to the
position illustrated below, in accordance
with step 2. (Fig. 25)
Dan
Adjusting
range
MIN
MAX
Fig. 25
Parts Identification
Fig. 1
[1]
Volume
buttons
Fig. 3
[17] Numeric display
Pressing the (+) side of buttons [1]
increases the volume, while the (-) side of
buttons [1] decreases it.
(Numeric display [17] shows "V 0 — V 30".)
Note:
+
Always keep the volume inside the car
at a level that allows you to hear outside
sounds.
Advertisement
Table of Contents
