Installation Precautions - Pioneer DRM-ULV16 Operating Instructions Manual

Installation Precautions

Take the following precautions into consideration when installing:
¶ This unit cannot be connected to an SE host bus adapter.
Always use an LVD host bus adapter.
¶ This unit cannot be used together with Power supply unit DRM-PW701 due to drive
installation limitations.
¶ Turn off power to the host computer and changer before connecting SCSI cables.
Nomenclature
Rear Connectors
1 SE SCSI termination switch (CHANGER)
Use to set changer's SCSI terminator ON/OFF. Factory default: ON
2 SCSI ID switch (CHANGER)
Use to set the changer's SCSI ID. Pressing the upper protrusion causes the number
to decrement, while pressing the lower protrusion increments the number. Factory
default: 6
3 LVD SCSI interface connector
Connect using the supplied (or optionally purchased) SCSI Cable (LVD), or supplied
SCSI Terminator (LVD).
4 SE SCSI interface connector
Connect to the changer's supplied SCSI Cable (SE).
Note:
Avoid touching the connectors, since faulty connection or damage from static
electricity may result.
5
<DRC1290> En