Baofeng UV-5R EX User Manual page 35

Visit Radioddity.com For Downloads And Help
CH [0]: Displays the
channel number
MDF-A-Channel
NAME [1]: Display the
21 Mode A Display
channel name
FREQ [2]: Display
programmed Frequency
CH [0]: Displays the
channel number
MDF-B-Channel NAME [1]: Display the
22
Mode B Display channel name
FREQ [2]: Display
programmed Frequency
BCL- Busy OFF [0] | ON [1]
Channel Lock-out
AUTOLK OFF [O] I ON[1]
OFF [0]: TX = RX (simplex)
+ [1]: TX will be shifted higher
SFT-D –
in frequency than RX
Frequency Shift
-[2]: TX will be shifted lower
Direction
in frequency than RX
58
[A] MR/Channel Mode Display Format
Note: Names must be entered using software
[B] MR/Channel Mode Display Format
Note: Names must be entered using software
Disables the [PTT] button on a channel that is
already in use. The transceiver will sound a
beep tone and will not transmit if the [PTT]
button is pressed when a channel is already
in use.
When ON, the two displays will sync. This
enables you to see both Channel Name
and Frequency at the same time (Use with
Menus 16&17)
PTT-ID Delay (milliseconds)
Visit Radioddity.com For Downloads And Help
OFFSET -
00.000-69.990 in 10 kHz
Frequency Shift
26
steps
amount
MEM-CH – Store
27 000-127
a Memory
DEL-CH-Delete
a memory
000-127
channel
OFF [0] | BLUE
WT-LED -
Display [1] | ORANGE [2]
| PURPLE [3]
backlight color,
RX-LED -
OFF [0] | BLUE [1] | ORANGE
Display
[2] | PURPLE [3]
backlight color-
Receive
59
Specifies the difference between the TX
and RX frequencies
This menu is used to either create new or
modify existing channels (0 through 127) so
that they can be accessed from MR/Channel
Mode.
This menu is used to delete the programmed
information from the specified channel (0
through 127) so that it can either be
programmed again or be left empty.
Default: PURPLE
Default: BLUE