Baofeng UV-5R EX User Manual page 34

Visit Radioddity.com For Downloads And Help
R-DCS-Receiver
OFF[0] see DCS Table in
10 DCS
Appendix C
OFF[0] see CTCSS
R-CTCS -
11
Table in
Receiver CTCSS
Appendix C
T-DCS- OFF[0] see DCS Table in
Transmitter DCS Appendix C
T–CTCS-
OFF[0] see CTCSS Table in
Transmitter
Appendix C
CTCSS
VOICE- Voice OFF[0]| ENG [1]|
Prompt CHI [2]
ANI-ID-
Automatic
Number ID
63
56
Mutes the speaker of the transceiver in
the absence of a specific low-level digital
signal. If the station you are listening to
does not transmit this specific signal, you
will not hear anything.
Mutes the speaker of the transceiver
in the absence of a specific and
continuous sub-audible signal. If the
station you are listening to does not
transmit this specific and continuous
signal, you will not hear anything.
Transceiver a specific low-level digital signal
to unlock the squelch of a distant receiver
(usually a repeater)
Transceiver a specific and continuous sub-
Audible signal to unlock the squelch of a
distant receiver(usually a repeater).
Allows audible voice confirmation of a key
press
Displays the ANI code that has set by
Software. This menu cannot be used to
change it. The ANI-ID is sent when the
alarm is activated and menu 32=CODE
Visit Radioddity.com For Downloads And Help
OFF [0]: No DTMF side
Tones are heard DT-ST
DTMFST- DTMF- [2]: Side Tones are heard
16 Side Tone of Only from automatically
Transmit code keyed DTMF codes
DT+ANI [3]: All DTMF Side
Tones Are heard
1[0] |2[1] |3[2] |4[3]
|5[4] |6[5] |7[6] |8[9]
S-CODE Signal
|9[8] |10[9] |
17
Code
11[10] |12[11] |13[12]
|14[13] |15[14]
To [0]: Time Operation-scan-
ning Will resume after a fixed
time has Passed CO [1]:
Carrier Operation-
SC-REV-Scanner
Scanning will resume after
Resume Method
the signal disappears
SE [2]: Search Operation-
Scanning will not resume
OFF [0]: No ID is sent
BOT [1]: The selected S-CODE
PTT-ID – When
is Sent at the beginning
to send the
EOT [2]: The selected S-CODE
PTT-ID
is Sent at the beginning and
ending
PTT-LT-Signal
0-50ms
Code sending
delay
57
Determines when DTMF Side Tones can be
Heard from the transceiver speaker.
Selects 1 of 15 DTMF codes. The DTMF
codes are programmed with software and
are up to 5 digits each.
Scanning Resume Method
When to Sand PTT-ID
Codes are sent during either the beginning
or ending of a transmission.
PTT-ID Delay (milliseconds)