Advertisement
BEFORE OPERATION
INSTALLING THE PLAYER
@ Choose a stable platform next to the television and
stereo
system
with
which
you
plan to use
the
player.
@ When
using the player with a stereo system, your
speakers should be installed somewhat separated
from your television (or TV monitor).
@ Do not place your television (or TV monitor) on top
of the player.
Also do not place the player on top
of your television (or TV monitor).
PROVIDE SUFFICIENT VENTILATION
Do not place the player on long pile carpet or on a
bed or sofa etc., as this may result in ventilation holes
becoming
blocked.
This would
impair heat dissi-
pation and could result in breakdown.
Also, do not place the player above an amplifier or
other
heat
generating
device.
When
putting
the
player in a rack together with other audio equipment,
the player should be placed on a lower shelf than the
amplifier (as low as possible so long as there is no
dust
build
up problem),
and
should
be used
after
ensuring good ventilation.
PUTTING
BATTERIES
INTO THE REMOTE
CONTROL
UNIT
1. Open the battery compartment cover on the rear of
the remote control unit.
The cover should open
easily if you press on it with your thumb
while
sliding it in the direction of the arrow.
. Take out the two accessory size "AAA" (IEC RO3)
dry batteries,
and
insert them
into the
battery
compartment in accordance with the indications in
the compartment.
. Close the cover of the battery case.
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A. Always
insert batteries into the battery compartment
correctly
matching
the
positive
(+)
and
negative
(-) polarities,
as
shown
by the
display
inside
the
compartment.
. Never mix new
and used batteries.
. Batteries of the same size may have differing voltages,
depending on brand.
Do not mix different brands of
batteries.
. Both rechargeable and non-rechargeable batteries are
available.
Be sure to use your batteries in accordance
with the caution labels affixed to them.
6
<VRB1001>
MOISTURE CONDENSATION
If the player is brought from cool surroundings into
a warm
room, or if the temperature of the room
rises
suddenly,
condensation
may
form
in the
operating system and objective lens of the player.
While
condensation
is present,
it will
not
be
possible for signals to be read out by the laser
beam.
Depending on the degree of condensation, let the
player stand for an hour or two
in its new
sur-
roundings with the power switched on. When the
player reaches room temperature, the condensa-
tion will evaporate, and playback will be possible.
The
same
symptoms
of condensation
may
be
caused
during summer, if the player is exposed to the breeze from
an air conditioner.
In such cases change the location of
the player.
NOTE
If the player is switched on during reception of FM or AM
broadcasts, the player may interfere with reception. When the
player is not being used, please switch it off.
Also, if the player causes interference when a broadcast is
being received with an indoor antenna, please adjust the direc-
tion of the antenna.
1 ESOC
SENSOR
SUNT
:
£
i
i
:
seg
DSO
HE HET
SSUES
EIEN
SLL
TS IEG
SOR
SEI
seth
RETA
AAI
THERA
ee
ANG TERIA
eS
<A RF ER ESE HSE
EES
ERED
I ENO
ESET
RET
TES ESSA
E N E
"See ENERO
ARTRTOST
Advertisement
