Advertisement
TROUBLESHOOTING
20 Picture other than that
@ Method of inputting numerals in the TIME NUMBER
SEARCH
mode differs, depending on whether
instructed is searched in TIME
time number is recorded on disc in minutes or seconds, as shown below:
NUMBER
SEARCH mode.
[e.g.]
12-minute search
@ Disc in which time number is recorded in minutes
FRAME/TIME
"minutes''
@ Disc in which time number is recorded in seconds
[FRAME/TIME
"minutes"
"seconds"
WHEN PLAYING BACK A COMPACT DISC
SYMPTOM
21 Player stops immediately
after starting playback.
REMEDY
e@ Load the disc correctly with the label side
upward.
@ Use a soft cloth and lightly wipe off the dirt
from the surface of the disc.
If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
e@ Disc is loaded upside down,
@ The playing surface of the disc is dirty.
22 No sound output
@ The stereo amplifier is not correctly connected.
e You are not operating the stereo amplifier
correctly.
@ The connection terminals and/or the plugs of the
connection cords ane dirty.
@ The plugs of the connection cords are
disconnected, or are not fully pushed in.
e@ You have connected the amplifier to the player
LV (ANALOG) AUDIO OUT terminals.
e@ Connect the ampifier correctly.
e Refer to the operating instructions for the
amplifier, and operate the amplifier correctly.
@ Clean the plugs and terminals and connect again.
@ Make sure that connections are correct.
@ Connect the amplifier to the CD/LV AUDIO
OUT terminals.
(The LV (ANALOG) AUDIO
OUT terminals, do not provide audio output
for Compact Disc playback.)
@ Press the PLAY key and restore the player to
PLAY mode.
@ Connect the CD/LV AUDIO OUT terminals
of the player, to the CD or AUX input terminals
etc, of the amplifier.
(Do not connect to the
PHONO input terminals of the amplifier.)
e Clean the plugs and terminals and connect again.
e@ The player is in PAUSE mode.
23 Sound is distorted
e The stereo amplifier is not correctly connected.
@ The connection terminals and/or the plugs of the
connection cords are dirty.
@ The plugs of the connection cords are not fully
pushed in.
e Push the plug in firmly.
@ The playing surface of the disc is dirty.
@ Use a soft cloth and lightly wipe off the dirt
from the surface of the disc.
If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
36
<VRB1001>
j
|
i
:
5
:
i :
:
id .
4
i
:
i
i
EE
TAN
ER SS
SEE STS
ES
EB
EEO
BP SET
ETERS
ST
SE
IEE
TEE
ESET
ET E O C E N E
AINTERNETRS
Advertisement
