Toshiba RAS-35S4KVDG-ND Owner's Manual page 7

9.5 Hi POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling or
heating operation (except in DRY and FAN ONLY mode).
1. Press MENU button for enter menu setting and press TEMP. button to
select Hi POWER.
2. Confi rm selected feature by press MENU button again.
When feature had selected will return to menu selection display triangle mark
will blink .
3. Leave from menu setting display by press EXIT button.
9.6 ECO OPERATION
To automatically control room temperature to save energy
(except in DRY and FAN ONLY mode).
1. Press MENU button for enter menu setting and press TEMP. button to
select ECO.
2. Confi rm selected feature by press MENU button again.
When feature had selected will return to menu selection display triangle mark
will blink .
3. Leave from menu setting display by press EXIT button.
Note:
● Cooling operation; the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).
For heating operation the set temperature will decrease.
Blink both triangle and
feature mark Feature
not yet set.
Blink only triangle
Feature already set.
Blink both triangle and
feature mark Feature
not yet set.
Blink only triangle
Feature already set.
9.7 FIREPLACE OPERATION
Keep indoor unit's fan blowing continuously during thermo off, to circulate heat
from other sources over the room. There are three setting parameters:
Default setting > Fireplace 1 > Fireplace 2
Fireplace 1:
● During thermo off period, the indoor unit's fan will continue to run by the
same speed, previously selected by end-user.
Fireplace 2:
● During thermo off period, the indoor unit's fan will continue to run at
super-low speed, programmed from factory.
Fireplace Operation Setting
1. Press MENU button for enter menu setting and press TEMP. button to
select FIREPLACE.
2. Enter FIREPLACE set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
3. Select FIREPLACE operation by press TEMP. button.
FIREPLACE1 FIREPLACE2
4. Confirm selected feature by press MENU button again.
When feature had selected will return to menu selection display triangle mark
will blink .
5. Leave from menu setting display by press EXIT button.
Note:
● While Fireplace operation on heating mode, indoor unit fan always runs
and cold air breezing might be occurred.
● Fireplace will operate in Heating mode only.
6
Blink both triangle and
feature mark Feature
not yet set.
Blink only feature
None
Blink only triangle
Feature already set.
EN