Craftsman 536.88626 User Manual page 7

Parts packed separately in carton (not shown full size)
1- Crank Assembly
2- Ignition Keys
(Attached to engine in plastic hag)
1-Snow Chute Assembly
ml II I I
,_ WARNING: Always wear
safety glasses or eye shields
wmle assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
1 - 1/2 inch wrenches
(or adjustable wrenches)
1 - 9/16 inch wrenches
(or adjustable wrenches)
1 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measudng tape or ruler
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's position behind
the unit.
Auger Drive Lever
Drive Lever
Shifter
Lever
Clutch Cable
Crank Assembly
Chute
Deflector
F-001088,/
Height
Adjust
Skid
Figure
2
TO REMOVE SNOW THROWER
FROM CARTON
1. Locate all parts packed separately
and remove from the carton.
NOTE: Place fuel stabilizer in a safe
Figure 1 place until needed for storage.
7