Craftsman 536.88113 Instructions Manual page 11

f!_.'x_*] =1 _I=] Ik'4
3/jSa-16 Hex
m Nut
3. "Rghten the 3/8-16" hex jam nut
against the knob securely.
Remote Chute
Control Knob
Control
Panel
Washer
Locknut
• Exposed
Thread
Figure 12
REMOTE CHUTE CONTROL
KNOB
1. Thread the 3/8-16" hex jam nut
onto the lever until the nut reaches
the end of the thread. See
Figure 13.
2, Thread the plastic knob as far as
possible and ensure that the knob
points forward.
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment section.
_" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
P" All assembly instructions have been
Figure 13
HEADLIGHT
The headlight on your snow thrower is
positioned down for packaging pur-
poses. Rotate upward for operating
position.
completed.
P" The discharge chute rotates freely.
_" No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_" Engine oil is at proper level.
._" Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
P" Become familiar with all controls-
their location and function. Operate
controls before starting engine.
F-001060J 11