Dell VERLAND TANDBERG Titan T2000 Owner's Manual page 95

Table 28. Event descriptions and recommended actions (continued)
Number Severity
221 Info.
224 Info.
232 Warning
233 Warning
235 Error
Info.
236 Error
Info.
237 Error
Info.
238 Warning
94 Events and event messages
Description/Recommended actions
● No action is required.
Snapshot reset has completed.
Recommended actions:
● No action is required.
Roll back of data in the indicated volume to data in the indicated snapshot has completed.
Recommended actions:
● No action is required.
The maximum number of enclosures allowed for the current configuration has been exceeded.
The platform does not support the number of enclosures that are configured. The enclosure
indicated by this event has been removed from the configuration.
Recommended actions:
● Reconfigure the system.
The indicated disk type is invalid and is not allowed in the current configuration.
All disks of the disallowed type have been removed from the configuration.
Recommended actions:
● Replace the disallowed disks with ones that are supported.
An enclosure management processor (EMP) detected a serious error.
Recommended actions:
● Replace the indicated controller module or expansion module.
An enclosure management processor (EMP) reported an event.
Recommended actions:
● No action is required.
A special shutdown operation has started. These special shutdown types indicate an
incompatible feature.
Recommended actions:
● Replace the indicated controller module with one that supports the indicated feature.
A special shutdown operation has started. These special shutdown types are used as part of the
firmware-update process.
Recommended actions:
● No action is required.
A firmware update attempt was aborted because of either general system health issues, or
unwritable cache data that would be lost during a firmware update.
Recommended actions:
● Resolve before retrying a firmware update. For health issues, issue the CLI show system
command to determine the specific health issues. For unwritten cache data, use the CLI
show unwritable-cache command
A firmware update has started and is in progress. This event provides details of the steps in a
firmware-update operation that may be of interest if you have problems updating firmware.
Recommended actions:
● No action is required.
An attempt to install a licensed feature failed due to an invalid license.
Recommended actions: