Dell VERLAND TANDBERG Titan T2000 Owner's Manual page 60

Figure 55. Removing a DDIC (2 of 2)
Installing a DDIC in a 5U enclosure
Failed disk drives must be replaced with approved disk drives. Contact your service provider for details.
1. Align the DDIC with the target drive slot and insert it into the drive slot.
2. Lower the DDIC into the drive slot.
a. Push the DDIC downwards and hold it down.
b. Move the slide latch in the direction shown in the following figure:
Figure 56. Installing a DDIC
1. Slide latch (slides left)
2. Latch button (shown in locked position)
3. Drive Fault LED
3. Verify the following:
a. The latch button is in the locked position.
b. The Drive Fault LED is not lit.
4. Close the drawer.
Populating drawers
The general guidelines for populating a drawer with DDICs are provided in the Dell PowerVault ME5 Series Storage System
Deployment Guide. Additional guidelines are provided for replacing disk drives in previously populated drawers, or populating
enclosures delivered with the half-populated enclosure configuration option.
Module removal and replacement 59