Craftsman 247.88855 Owner's Manual page 23

• Reassemble the new friction wheel rubber to
the friction wheel assembly tightening the six
screws in rotation and with equal force.
• Position the friction wheel assembly up onto
the pin of the shift rod assembly and slide the
shaft through the friction wheel. See Figure 30.
• Slide the shaft into the hex I.D. of the sprocket,
the spacer and the left ball bearing and secure
with the bell washer and hex bolt.
Spacer
Bearing
Washer
Bolt
Bracket
Carburetor Carburetor
WARNING: If any adjustments are made to WARNING: If any adjustments are made to
the engine while the engine is running (e.g. the engine while the engine is running (e.g.
carburetor), keep clear of all moving parts. carburetor), keep clear of all moving parts.
Be careful of heated surfaces and muffler. Be careful of heated surfaces and muffler.
If you think the carburetor needs to be adjusted, see If you think the carburetor needs to be adjusted, see
your nearest authorized Tecumseh Service Outlet. your nearest authorized Tecumseh Service Outlet.
Sprocket Shift Rod
Assembly
Pin
Support
Figure 30
23
Shaft
Friction
Wheel