Table of Contents
Advertisement
This change remains in effect until scan is turned off. Scan then reverts to the default setting.
Procedure:
•
Making a Dynamic Priority Change using the preprogrammed Dynamic Priority button:
a. When the radio locks onto the channel designated as the new Priority-Two channel, press
the preprogrammed Dynamic Priority button.
The radio continues scanning the remaining channels in the list.
2.3.3
Deleting a Nuisance Channel
When and where to use:
If a channel continually generates unwanted calls or noise (termed "nuisance" channel), you can
temporarily remove the unwanted channel from the scan list.
This capability does not apply to priority channels or the designated transmit channel.
Procedure:
When the radio is locked onto the channel to be deleted, perform one of the following actions:
•
Press and hold the Menu Select button below Scan or preprogrammed Scan button to
delete the nuisance channel.
•
Press the preprogrammed Nuisance Delete button.
•
Press the Menu Select button directly below Nuis.
The radio continues scanning the remaining channels in the list.
2.3.4
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
•
Stop and restart a scan.
•
Mode change to another channel and back to the original channel.
•
Turn off the radio and then turn it on again.
Nuisance mode delete can be disabled by the system administrator.
2.4
Call Alert Paging
This feature allows your radio to work like a pager.
The radio which you missed its call can send a Call Alert page to your radio. The sender can also verify
if your radio is active.
NOTICE: This feature must be preprogrammed by a qualified radio technician.
68012005016-DJ
Chapter 2: Advanced Features
47
Advertisement
Table of Contents
