SAFETY INSTRUCTIONS 1.1 The appliance you have purchased is a technologically advanced product designed by one of the leading European manufacturers of high pressure washers. To obtain the best performance from your unit, read this booklet carefully and follow the instructions each time you use it.
0 Switch “OFF” position I Switch “ON” position Guaranteed sound power level Prohibition sign, informs users that local regulations may prohibit connection of the product to the drinking water supply system. Danger sign, warns users not to direct the water jet at people, animals, elec- trical equipment or the product itself.
Page 8
SAFETY RULES/RESIDUAL RISKS SAFETY “DO NOTS” 3.1.1 W . DO NOT allow children to use the appliance; supervise them to ensure ARNING that they do not play with it. 3.1.2 W . High pressure jets may be dangerous if incorrectly used. ARNING 3.1.3 W .
Page 9
3.1.19 W . DO NOT allow vehicles to drive over the high pressure hose. ARNING 3.1.20 W . DO NOT move the appliance by pulling on the high pressure hose. ARNING 3.1.21 W . When directed towards tyres, tyre valves or other pressurised ARNING components, the high pressure jet is potentially dangerous.
Page 10
3.2.12 W . Water that has passed through back ow preventers is considered to ARNING be non-potable. 3.2.13 W . Maintenance and/or repair of electrical components MUST be carried ARNING out by quali ed sta . 3.2.14 W . DISCHARGE residual pressure before disconnecting the hose from the ARNING appliance.
Page 11
- Thermostat valve (D1 where tted) If the water temperature exceeds the temperature set by the manufacturer, the thermostat Use of the manual valve discharges the hot water and draws in an amount of cold The manual forms an integral part of the appliance and should be water equal to the amount of water discharged, until the correct kept for future reference.
Page 12
Adjusting the detergent Re lling and using detergent The detergent must be delivered using the accessories and by To deliver detergent at the correct pressure, set the nozzle (E) the procedures described in point 7.3. (where tted) on " " or t the detergent kit (C13) (where available) Use of a high pressure hose longer than the one originally supplied as shown.
TROUBLESHOOTING Problem Possible causes Remedy Nozzle worn Replace nozzle Water lter fouled Clean lter (L) ( g.5) Insu cient water supply Turn on water supply tap fully Air being sucked into system Check tightness of hose ttings Switch o the appliance and keep depressing and releas- Pump does not reach working Air in pump ing the gun trigger until the water comes out in a steady...
12.4 Never use the “Turbo Lance” for washing any part of the vehicle. 12.5 For further information refer to section: “8.7 Recommended cleaning procedure”. Technical Data Technical Data Unit HDC140-110V Max Pressure Working Pressure Max Rated Flow Working Rated Flow...
Need help?
Do you have a question about the HDC140-110V and is the answer not in the manual?
Questions and answers